DATASCOPE CORP. 709000323 Rotaflow Home Pack - Softline

The Meditech ABPM-04 Ambulatory Blood Pressure Monitor automatically measures the systolic and diastolic arterial blood pressure and the pulse rate of adult patients under ambulatory circumstances using the standard oscillometric method with a standard upper arm cuff, sequentially as programmed by the adjoining software. The device is intended for use with the standard indications and contraindications for ambulatory blood pressure monitoring.

The Meditech ABPM-05 Ambulatory Blood Pressure Monitor automatically measures the systolic and diastolic arterial blood pressure and the pulse rate of adult patients under ambulatory circumstances using the standard oscillometric method with a standard upper arm cuff, sequentially as programmed by the adjoining software. The device is intended for use with the standard indications and contraindications for ambulatory blood pressure monitoring.

The R2*/T2* phantom is a medical device accessory intended to be used as an alternative to human test subject to avoid potential complications for an MRI centre in order to evaluate that the scanning protocol have been correctly set up for the analysis of cardiac R2* and T2* values using the CardiacT2* on 1.5T and 3T MRI scanners. The R2*/T2* Phantom consists of an amber bottle having 09 (nine) plastic tubes (30mL) of 0.8% Agarose (C24H38O19) gel doped with varying known concentrations (0.10 mM to 3.2 mM) of manganese chloride (MnCl2).

Standalone software as medical device (SaMD) designed to automatically analyse within seconds magnetic resonance imaging (MRI) datasets to generate an estimate of the patient’s volumetric liver fat fraction (VLFF), converted into proton density fat fraction (PDFF) and steatosis grade. No user input is required for the analysis thus minimising the impact of human error on obtained results. HepaFatSmart is intended for the quantitative evaluation of volumetric liver fat fraction (VLFF), proton density fat fraction (PDFF) and liver steatosis grading.It utilises magnetic resonance images that exploit the difference in resonance frequencies between hydrogen nuclei in water and triglyceride fat. The quantitative triglyceride fat fraction is based on the measurement of a magnetic resonance parameter that reflects the ratio of the proton density signal of triglyceride fat to the total proton density signal in the liver.When interpreted by a trained physician, the results provide information that can aid in diagnosis.HepaFatSmart is indicated to:• Support clinical diagnoses in individuals with confirmed or suspected fatty liver disease; • Assessment of liver fat content to support the subsequent clinical decision-making processes for patients under management of diseases such as non-alcoholic fatty liver disease (NAFLD), non-alcoholic steatohepatitis (NASH), viral hepatitis. • Support the subsequent clinical decision-making processes for patients Results, when interpreted by a trained physician can be used to support clinical diagnoses about the status of liver fat content, the subsequent clinical decision-making processes for the management of fatty liver related diseases.

The AnovoTM Surgical System is a robotic-assisted device intended for use by laparoscopic trained physicians for endoscopic manipulation of tissue, using graspers and electrosurgery devices during single-site laparoscopic gynecologic procedures such as benign hysterectomy and salpingo-oophorectomy through a transvaginal access point. The system composed of Anovo Surgeon Console, two sterile instruments (Anovo Instrument ARMS), bed-mounted Robotic Control Unit (RCU) and Anovo System Accessories [Unit cables, Sterile Drapes, Robotic Control Unit Support System (RCUSS) and Vaginal Access Kit]. Anovo Surgeon Console (UDI # 07290018151013) packed with its power cable (UDI # 07290018151037), Robotic Control Unit (RCU) (UDI # 07290018151044) and Unit Cables (UDI # 07290018151051)

The AnovoTM Surgical System is a robotic-assisted device intended for use by laparoscopic trained physicians for endoscopic manipulation of tissue, using graspers and electrosurgery devices during single-site laparoscopic gynecologic procedures such as benign hysterectomy and salpingo-oophorectomy through a transvaginal access point. The system composed of Anovo Surgeon Console, two sterile instruments (Anovo Instrument ARMS), bed-mounted Robotic Control Unit (RCU) and Anovo System Accessories (Unit cables, Sterile Drapes, Robotic Control Unit Support System (RCUSS) and Vaginal Access Kit). Anovo Surgeon Console (UDI # 07290018151013) packed with its power cable (UDI # 07290018151037)The Anovo Surgeon Console comprised of Arm Controllers (Joysticks and Thumbsticks), an Adjustable Controllers Stand, a PC with Touch Screen, Manual Release Tool and the Power Adapter, and allowing the operating surgeon to operate the Anovo Instrument Arms. There are two sets of Arm Controllers for the Anovo System: two Thumbsticks and two ARMS Controllers. The ARMS Controllers are enabled only when the system is at “resume” state and allow for the accurate control of the Anovo Instrument ARMS during the surgical procedure. Like the Anovo Instrument Arm, each ARMS Controllers has three joints: wrist, elbow and shoulder, so that each Anovo Instrument ARM moves accordingly to Controller's movement. The surgeon-held Controller handle is above the elbow joint and allows for multiple functionality transitions.

The Visual LED Indicator is used to remotely monitor the operating status of a connected device (e.g. the reverse osmosis water treatment system).The status of a connected device is signaled:– Visually by three indicator lights (green, yellow, and red)– Acoustically by a sound generatorAn acoustic status signal can be muted temporarily at the touch of a button.The signaling device can currently be operated with the following reverse osmosis systems from Fresenius:– AquaA– AquaBplus

The AquaDETECTOR leakage monitoring system provides full leakage monitoring of a dialysis center in the monitored areas. It can be used to switch off dialysis water supply systems, dialysis concentrate preparation systems, dialysis concentrate supply systems, booster pump assemblies, and pre-filtration devices that are connected to the central control unit.This device can be used with the AquaA and AquaBplus water purification systems.

Planmeca Pro50 Chair is an elegant yet sturdy patient chair with telescopic lifting mechanism.Beautiful and timeless design with metal coversWide height range from 390 mm to 890 mmSlim backrest and small chair base for optimal access to the treatment areaFolding legrest as standard featureSmooth and silent movements with medical grade electrical lifting motorsMaximum patient weight: 185 kg

The Meditech ABPM-04 Ambulatory Blood Pressure Monitor automatically measures the systolic and diastolic arterial blood pressure and the pulse rate of adult patients under ambulatory circumstances using the standard oscillometric method with a standard upper arm cuff, sequentially as programmed by the adjoining software. The device is intended for use with the standard indications and contraindications for ambulatory blood pressure monitoring.

The Meditech ABPM-05 Ambulatory Blood Pressure Monitor automatically measures the systolic and diastolic arterial blood pressure and the pulse rate of adult patients under ambulatory circumstances using the standard oscillometric method with a standard upper arm cuff, sequentially as programmed by the adjoining software. The device is intended for use with the standard indications and contraindications for ambulatory blood pressure monitoring.

The R2*/T2* phantom is a medical device accessory intended to be used as an alternative to human test subject to avoid potential complications for an MRI centre in order to evaluate that the scanning protocol have been correctly set up for the analysis of cardiac R2* and T2* values using the CardiacT2* on 1.5T and 3T MRI scanners. The R2*/T2* Phantom consists of an amber bottle having 09 (nine) plastic tubes (30mL) of 0.8% Agarose (C24H38O19) gel doped with varying known concentrations (0.10 mM to 3.2 mM) of manganese chloride (MnCl2).

Standalone software as medical device (SaMD) designed to automatically analyse within seconds magnetic resonance imaging (MRI) datasets to generate an estimate of the patient’s volumetric liver fat fraction (VLFF), converted into proton density fat fraction (PDFF) and steatosis grade. No user input is required for the analysis thus minimising the impact of human error on obtained results. HepaFatSmart is intended for the quantitative evaluation of volumetric liver fat fraction (VLFF), proton density fat fraction (PDFF) and liver steatosis grading.It utilises magnetic resonance images that exploit the difference in resonance frequencies between hydrogen nuclei in water and triglyceride fat. The quantitative triglyceride fat fraction is based on the measurement of a magnetic resonance parameter that reflects the ratio of the proton density signal of triglyceride fat to the total proton density signal in the liver.When interpreted by a trained physician, the results provide information that can aid in diagnosis.HepaFatSmart is indicated to:• Support clinical diagnoses in individuals with confirmed or suspected fatty liver disease; • Assessment of liver fat content to support the subsequent clinical decision-making processes for patients under management of diseases such as non-alcoholic fatty liver disease (NAFLD), non-alcoholic steatohepatitis (NASH), viral hepatitis. • Support the subsequent clinical decision-making processes for patients Results, when interpreted by a trained physician can be used to support clinical diagnoses about the status of liver fat content, the subsequent clinical decision-making processes for the management of fatty liver related diseases.