RESMED PTY LTD 27926 ASTRAL

The Efficia CMS200 Central Monitoring System is a "Software with IT Equipment" solution to provide central viewing of physiologic waves, parameters, and trends from other LAN networked Efficia CM monitors , G series and SureSigns VM4/6/8 monitors (requires sw rev. A.03.93 or later) for up to 64 patients at the same time. It provides for the retrospective review of alarm conditions, physiologic waves and parameters from multiple patients (Up to 240 hours of tabular and graphic trends, ECG waveform, alarm events and full disclosure waveforms). It is built on one Philips supplied HP PC with customized embedded Windows 10 OS, supporting 23" 16:9 high resolution HP displays, 24-port network switch(switch is for selected market), one set of mouse and keyboard(keyboard is for selected market) and one USB licensing dongle. It also can be used with a laserjet printer for printing out reports. The printer can either be Philips supplied or locally sourced. It also has the capability to export HL7 data to EMR/HIS via a second network card. A UPS is not included and recommended to be source locally.

The Nelson Sentinel Series Basic Chlorine Sentinel is a complete system that attaches to the drain of a hemodialysis water treatment system sample port. The Basic Chlorine Sentinel detects dissolved chlorine by an auxiliary meter detection technology, self-monitors for maintenance-required conditions, loss of electrical power, as well as two other system conditions such as flooding and the status of RO shutdown alarm. The device chlorine monitoring probe is preferably placed after the second carbon filter, before the RO machine or at the beginning of the patient water treatment loop.The device has three components – a lockable master control enclosure, a lockable probe/tester enclosure, and the remote module installed in the patient area.A chlorine concentration equal to or above the set-point (default: 0.10mg/L) will activate the buzzers and the red CHLORINE alarm indicators for as long as the condition exists. The buzzers can only be muted for 3 minutes (then automatically reset) for as long as the condition exists. The yellow AUTO-TEST OK/CL DETECTED indication will latch. The AUTO-TEST/CL DETECTED indication can be deactivated after the event by pressing the blue RESET PUSHBUTTON on the front cover of the controller.A probe failure or the activation of one of the auxiliary input relays will activate the yellow MAINTENANCE needed indicators as well as the Buzzers which will remain activated as long as the condition exists. However, the buzzers can be muted by the key mute switch while the maintenance issue is being resolved.