Smiths Medical ASD, Inc. 80-01-040 CADD

The Quantum Thermal Transfusion Set- Blood from LifeWarmer is the revolutionary IV tubing set that allows for safe, rapid warming of blood, blood products, or IV fluids without adding hardly any additional steps to the normal IV setup process. Modeled after standard blood infusion tubing, the familiar configuration allows for ease of use. The sophisticated intelligence and proprietary warming technology are integrated into the tubing system for simplicity and to reduce additional equipment and procedural steps. Roughly the same size and weight as standard blood tubing, there is almost no additional equipment burden.The Quantum IV administration tubing is double-extruded to yield a configuration that has both an inner tubing layer and an outer tubing layer. A conductive heating element is between the two layers but does not come in contact with the fluid path or disrupt the laminar flow. The outer tubing layer acts as an insulator while the inner tubing layer transfers the heat from the heating element to the fluid path. Thermistors located in the tubing continually measure temperature and provide that input to the Quantum Controller. The monitoring and independent application of energy (heat) along the fluid path allows the Quantum to respond to varying temperature inputs from the fluid source to near the point of patient entry to ensure fluid temperature is the right temperature at delivery.The Quantum Life Warmer, fully charged, is able to warm and maintain up to 2 units ( 900mL +/- 100mL) of cold (4C) blood products or IV solutions to a pre-set temperature of 100.4F (38+/- 2C) at a flow rate of 100 mL/min (depending on the ambient temperature). Or, approximately 1700 mL of 20C IV solution to a set point of 38C +/- 2C at a flow rate of 200 mL/min. Effective warming flow rates range from 2 to 200 mL/minute depending on input fluid temperature and ambient conditions.

The Quantum Battery from LifeWarmer is an extremely powerful and intelligent battery in a small, lightweight package- weighing only 16 oz. The Quantum Battery powers the whole warming system with state-of-the-art Lithium Polymer cells harnessing 44 Volts of electrical potential. The battery, fully charged, is able to warm and maintain up to 2 units ( 900mL +/- 100mL) of cold (4C) blood products or IV solutions to a pre-set temperature of 100.4°F (38+/- 2C) at a flow rate of 100 mL/min (depending on the ambient temperature). Or, approximately 1700 mL of 20C IV solution to a set point of 38C +/- 2C at a flow rate of 200 mL/min.The Quantum Battery is built for use in the most austere and tactical environments. It is IP67 rated for water resistance and is the only portable fluid warming battery that has a disable feature on the audible alarm for tactical considerations. The Quantum Life Warmer Battery is rechargeable with a service life of 500 charge/discharge cycles.It is important to keep the Quantum Battery charged and ready for use. Always re-charge after deployment, even if the battery was not fully discharged. The battery can be kept plugged into the Quantum Charger, as the intelligent Battery senses charge demand and will charge as needed but never overcharge. The Battery has a “Status” button to check the state of charge at any moment, with 3 colored LEDs to inform the user about the condition of the battery.

The Quantum Charger from LifeWarmer is an AC-powered reusable device that can fully charge the Quantum Battery rapidly and safely. The Charger has built-in algorithms to ensure proper, steady charging without overcharging or damaging the health and integrity of the battery. The Battery can go from nearly 0% to full within 90 minutes. The Life Warmer Charger has two colored LED lights to inform the provider of the status of charge and condition of the battery.The Quantum Battery Charger connects to the Battery via an omni-directional plug that allows for rapid energy transfer while prioritizing safety even in cases of hasty disconnection. The Quantum Battery will alert the user if there is any issue associated with the health of the battery. The Charger comes supplied with a 6-foot AC power cord.

QinFlow Blood and Fluid Warmer QiF-01 Base Unit (BU). The BU controls the performance of the system and the outflow fluid temperature. The BU contains firmware (SW) and electronics (HW), a graphic display and audio speaker for user notifications.

Warrior pole mounting is used with Warrior/Warrior EXTREME system

an Extension cable for connecting the system Base Unit (of Warrior/Warrior EXTREME) and the system Disposable Unit/Compact Disposable Unit